Mazda 1978 GLC Manual, Instructions; Maintenance And Servicing

7, OPERATING CAUTION Your Mazda Emission Control System can produce oonsiderable heat. T 0 - avoid problems, please be sure to observe the following precaution: Do not operate or park the vehicle in areas where flammable materials such as dry grass ma…

24, COMBINATION CONTROL LEVER 1. Turn and Lane.change Signals For signaling turns, move the lever up or down in conventional manner. 2. Headlight Beam Control With the headlights on, the high and low beams are selected alternately, each time the leve…

49, CHANGING ENGINE OIL AND OIL FILTER CHECKING ENGINE OIL LEVEL The engine oil should be checked at each fuel stop and maintained at proper level. 1. Be sure the vehicle is on level ground. 2. Turn off the engine and allow five minutes. 3. …

72, Oil capacity: Manual (4·Speed) Manual (5·Speed) Fluid capacity (automatic) REAR AXLE Final gear ratio Oil capacity STEERING Type Gear ratio Steeri ng wheel free play Min. turning radius 1.4 U.S. quarts (1.1 Imp. quarts, 1.31itersl 1.8 U.S. quarts (1.5 Imp. …

22, Mazda 1978 GLC HAZARD WARNING FLASHER Both turn signal indicator lights will flash at the same time when the hazard warning flasher switch is on. TRIPMETER RESET KNOB Push the knob in to reset the tripmeter to zero. This should be done only when the vehicle …

59, FUSES Use only specified fuses if replacement is necessary. If an electrical failure occurs, che ck for a blown fuse, and replace as necessa~y . If the same fuse blows again, avoid use of the system involved and bring the problem immediately to …