Huvitz HPE-810 Operation & User’s Manual

108, 108 108 HPE-810 HUVITZ <Hole Editor> Default settings for hole editor screen  Hole Depth – Set default hole/slot depth value  Hole Diameter – Set default hole/slot diameter value  Angle Default Options – Set default tilting angle mode and manual…

10, 10 10 HPE-810 HUVITZ 2.2. Safety Symbols The International Electrotechnical Commission (IEC) has established a set of symbols, which are listed below. This applies only to the instrument that has the certification symbol printed explicitly on the product label or sticker. …

102, Huvitz HPE-810 102 102 HPE-810 HUVITZ 7.2. Configuration of Edger Press the MENU button at the bottom left of the Main screen. <MENU Screen> ① Preferences ② Adjustments ③ Software Version ④ Exit ⑤ Shutdown NOTE  Refer to ‘Chapter 8. System …

88, 88 88 HPE-810 HUVITZ 6.7.5. List of Hole/Slot It displays the hole / slot list of the current job. You can change the position of the hole / slot by pressing the coordinates displayed on the list. Select the hole / slot: You can select the holes / slots to ma…

98, 98 98 HPE-810 HUVITZ 6.10. Frame Change 6.10.1. Frame Change Lens Registration This function is for registration of the frame change lens for frame change processing. To register the frame change lens, double-click (or long click) the job number area after selecting the frame c…

55, 55 55 NOTE  Global modification function is to move the entire edging position to the lens front surface or rear.  Move front  Move Rear …