Impulse IT8016 Assembly Instructions Manual

5, Impulse IT8016 3 Hardware List 0 100 10 20 30 40 50 60 70 80 90 110 120 130 140 150 Inches 0 123456 / 12 / 14 / 34 / 34 / 34 / 34 / 34 / 34 / 14 / 14 / 14 / 14 / 14 / 12 / 12 / 12 / 12 / 12 Millimeters …

7, 5 Assembly instructions Assembly of the takes professional installers 2 hours. If this is the first time you have assembled this equipment, plan to spend more time. It is strongly recom to assemble the equipment by professional installers. You may find it quicker, safer, easier to assemble …

9, 7 Step2 Assemble The Frame 1)Attach the Front Cross Frame(#2) and the Low Rear Cross Frame(#6)to the Main Upright(#1) using: 2)Attach the seat support(#4) to the Low Cross Frame (#2) and the Rear Cross Frame(#6) and secure it using: four Allen Bolts(#52) M10×115 four Nylon Locknuts(#67) M10 e…

17, 15 Step10 Assemble Pads 1) three Washers(#64) two Allen Bolts(#56) M10×30 one Allen Bolt(#53) M10×70 Attach the Back Pad(#15) to the Slide Frame(#5) using: 2) ΦΦ11× 20×2 two Screws(#80) M6×15 Attach the Plastic Cap(#79) to the Main Upright(#1) using: Note For a safe exercise,…

15, A B C Clip Top plate Jam nut 13 Step8 Route The Cable 1)Put the clip tied on the weight pin leash onto the Top Plate(#31) as shown, next connect the Cable(#18) to the Top Plate(#31). 2)Route the Cable(#18) up and over the two Pulleies A (#25).then secure them to the Main Upright(#1) us…

13, 11 Step6 Assemble The Slide Guides Align the Slide Frame(#5) to the Seat Support(#4),insert both Slide Guides(#11) through the Seat Support(#4) and the two Bearing Holders(#7,#8) located under the Slide Frame(#5) and secure them using: two Allen Bolts(#62) M8×15 …