INOX EL60 Operation & User’s Manual

16, 15 ADD/CHANGE A MANAGER CODE: PROGRAM 1XX Manager Codes are located at locations 00, 10, 20, 30, 40, 50, 60, 70, 80 and 90 (see table 1A on page 04). NOTE: New Manager Codes must use the same number of digits as the (new) Master Code. [Current Master/Sub-Master Code] (#) (1) [2-digit Locati…

4, 03 PROGRAMMING INITIAL SETUP: 1. Remove batteries. Press and hold (#) while connecting the batteries back. Release after hearing 5 beeps. Within 3 seconds, press (#) keypad 3 times. The BLUE LED will continuously light for 3 seconds and 2 beeps will be heard. 2. The unit is now clear of a…

20, 19 2 3 4 5 6 13 14 15 16 17 18 19 23 INSIDE ROSE MOUNTING PLATE LATCH BACK PLATE BATTERY COVER SCREW BATTERY COVER WITH FOAM INSERT BACK PLATE SHORT MOUNTING BOLTS (X2) INNER PLATE MOUNTING BOLTS (X2) BACK PLATE MOUNTING BOLTS (X2) ROSE MOUNTING BOLTS (X2) STRIKE PLATE BATTERY HOLDER INSIDE ROSE I…

10, ENABLE ALL: PROGRAM 4 ## [Master, Sub-Master, Manager Code] (#) (4) [1-digit Bank Number] (#) EXAMPLE: Assuming that the current Master, Sub-Master or Manager Code is (1) (2) (3) (4) (5). Press (1) (2) (3) (4) (5) • (#) (4) (3) (#) •• NOTE: If Master or Sub-Master Code was use…

21, 2 0 ASSEMBLY PARTS 1. INSIDE LEVER 2. BATTERY COVER SCREW 3. BATTERY COVER WITH FOAM INSERT 4. BACK PLATE SHORT MOUNTING BOLTS (X2) 5. INNER PLATE MOUNTING BOLTS (X2) 6. BATTERY HOLDER 7. INNER MOUNTING PLATE 8. LATCH RETRACTOR ASSEMBLY 9. PLATE MOUNTING BOLTS (X4) 10. OUTER MOUNTING PLATE 11. S…

6, INOX EL60 Codes may be 3, 4 or 5 digits long. The length of the Master Code determines all the codes format. Once the numbers of digits are selected. It cannot be changes unless all programming is erased and the default factory setting are reloaded. No other programming commands will be accepted u…