Intek Elite 16D Installation & Programming Manual

40, Page 40 SETTING THE REAL TIME CLOCK - P730E - P734E This block of addresses is used to set the internal real time clock used by the time zone functions. P730E 1-7E Set day of the week - where values of 1-7 represent Sunday to Saturday (Sunday = 1) P731E …

22, Page 22 OUTPUT AUTO ON/OFF TIME ZONES - P121E - 128E This block of addresses are used to map automatic turn on and turn off periods to each of the outputs where required. The start of the time zone will cause outputs mapped at these addresses to turn on whereas the end of the t…

19, Page 19 USER CODE PERMISSIONS (Code Options) 1st Set - P25E-P48E Option 0 - Turns all options off Option 1 - Code has Area A permissions Option 2 - Code has Area B permissions Option 3 - Code has Area C permissions Option 4 - Code can Arm Area Option 5 - Code can Disarm Area O…

11, Intek Elite 16D Page 11 When the Elite is displaying codes and address values in program mode it may be necessary to display the 9 and 0 digits. As there are no Zone indicators for 0 and 9 the "A" and "B" indicators are used. ie. When displaying values in program mode LIGHT OFF ON S…

65, Page 65 P301E Zone 1 vibration sensitivity - Default 0 0 = No vibration sensor Page 30 P302E Zone 2 vibration sensitivity - Default 0 Sensitivity 1-8 Page 30 P3…

77, Page 77 INITIATING A PRINT COMMAND If a user has permission to print the event log to a printer they must first enter client program mode eg <PROGRAM><CODE NO.><ENTER> (program LED on steady) THEN ENTER <PROGRAM><726><ENTER> Up to 63 events will…