Janome 6260QC Service Manual

25, Janome 6260QC Replacing A-Board and Fuse To Replace the A-board: 1. Remove the rear cover (see page 9). 2. Remove the 3 setscrews (A) and unplug the connectors from the A-board. 3. Remove the 6 setscrews (B) and 2 setscrews (C) then remove the board supporter and function button frame. 4. Remove the 2 s…

10, Setscrew (A) Front cover Service Access (5) Front cover To remove: 1. Remove the face cover, top cover and belt cover. (See pages 4-6.) 2. Remove the setscrews (A) to (E) and loosen the setscrew (F). To attach: 3. Follow the above procedure in reverse. Setscrew (B) Setscrew (E) Setscrew (D)…

2, Table Of Contents What To Do When ................................................................................................................ 1-3 Service Access Face Cover ................................................................................................................…

31, Setscrew (A) CS ring CS ring CS ring F-board Replacing Slide Volume and F-Board Replacing the slide volume control To remove: 1. Remove the front cover (see page 8). Unplug the slide volume connector. 2. Remove the 6 CS rings and replace the slide volume. Replacing the F-board To rem…

20, Mechanical adjustment Backlash between Hook Gear and Lower Shaft Gear The rotary play of the hook point should be 0.8 mm or less when it is in between the span of the feed dog teeth. And, the gears should turn smoothly. Adjustment procedure: 1. Remove the needle plate (A) and bob…

19, Mechanical adjustment Clearance between Needle and Hook The clearance between the needle and hook should be -0.10 to +0.05 mm. Adjustment procedure: 1. Select the zigzag stitch “ “ and set the stitch width at “7.0”. 2. Remove the needle plate (A) and bobbin holder (B). 3. Replace the ne…