Janome MO200 Service Manual

24, Janome MO200 23 MO200 5200QDC CORRECT RESULTS The display shows "Foot Controller" and the machine beeps. • When the foot control is not depressed, the screen should display "000" to "016". • When the foot control is depressed fully, the screen should display "2…

22, 21 MO200 5200QDC CORRECT RESULTS • The display shows "Self check start". LCD and led blinks. • Beeps when enter the LCD & LED check mode. Press CLR button to proceed to the next step. The display shows "Key" and the machine beeps. • Beeps when enter the key check mode.…

9, 8 MO200 5200QDC MECHANICAL ADJUSTMENT NEEDLE DROP POSITION Set the stitch pattern at " "; the standard needle drop position should be at the center of the needle plate hole. When the needle swings in maximum zigzag width " ", the distance between both ends of th…

32, 31 MO200 5200QDC REPLACING THE FEED MOTOR TO REMOVE: 1. Remove the base cover (see page 3). 2. Remove the front cover (see page 5). 3. Disconnect the connector from the board "A". 4. Remove the snap ring (E-3). 5. Remove the two setscrews (A), (B) and remove the feed motor…

33, 32 MO200 5200QDC REPLACING THE NEEDLE PLATE MOTOR TO REMOVE: 1. Remove the base cover (see page 3). 2. Remove the front cover (see page 5). 3. Disconnect the connector from the board "A". 4. Remove the two setscrews (A) and remove the needle plate motor. TO INSTALL: 5. To…