Jesco TOPAX DE Operating Instructions Manual

31, BA-40400-02-V14 | 31 Operating instructions 12.1.6 Menu 1.3: Trend representations mg/l pH °C Zoom- Zoom+ ESC 0.39 7.02 26.3 1.3 display 24 h. Fig.24: Main menu >> trend The actual trend of the measurements is represented by coloured curves. These can be constructed at diff…

23, Jesco TOPAX DE BA-40400-02-V14 | 23 Operating instructions 5.3 Measurement output Redox potential The REDOX potential can be used to control the disinfection perfor- mance. 5.3.1 Technical data Power output Values Input Voltage signal of a Redox single-rod measuring cell (0-1000 mV) Input resistance …

6, 6 | BA-40400-02-V14 Two-Channel Controller TOPAX DE 3.1 Recommended cables Recommended cables for the different connections and applications: Connections and applications Dimensions Types Mains voltage M20 X 1.5 NYM-I 3 x 1.5 mm (9.1 mm) Relay output (ATE- engine) M20 X 1.5 NYM…

29, BA-40400-02-V14 | 29 Operating instructions 12 Menu configuration and main settings 12.1 Menu of TOPAX In this chapter all of the TOPAX menus are presented and their operation exemplified. As the display is in colour and high resolution, the menus are shown in text and are clearl…

20, 20 | BA-40400-02-V14 Two-Channel Controller TOPAX DE 5.1 Measurement input Disinfection (amperometric measurement cells) To measure the disinfection, amperometric measuring cells are used. These measuring cells are used to measure the concentration of the free hypochlorous acid ions if chlorin…

22, 22 | BA-40400-02-V14 Two-Channel Controller TOPAX DE bration a buffer solution of pH 6.80 is available. When soaking the Ph- electrode in this solution, a voltage of 12 mV should be displayed on the TOPAX. The physical value actually measured is, however, always different from the theroretica…