Joysway DRAGONFORCE 65 Instruction Manual

3, INSTRUCTION MANUAL 3 BOW The front of the boat. STERN The back of the boat. PORT This is the left side of the boat when viewed from the Stern. STARBOARD This is the right side of the boat when viewed from the Stern. HULL The body of the boat. DECK The upper surface of the Hull. …

12, INSTRUCTION MANUAL 12 SHEETING SETUP 1 For initial sheet setup of both the Jib and Mainsheet, pull the winchline in to its close-hauled (sheeted fully in) position and don’t move it until both sheets are fully installed. 2 Cut a 500mm length of Dyneema for the Mainsheet. Tie a …

15, Joysway DRAGONFORCE 65 INSTRUCTION MANUAL 15 Item No Item Name 880502 Standard keel with screws 880503 Rudder 880504 550g standard ballast 880510 Sheeting pulley block 880511 1m Sheeting elastic 880519 Winch line rubber cap (pk2) 881210 Bowsie(PK10) 880532 Deck eyes (pk10) 880565 DF65 V5 Pear shaped mainsail…

11, INSTRUCTION MANUAL 11 POWERING UP THE BOAT If you’ve bought the ‘Ready To Race’ version (8815) of the boat you will have the Joysway Transmitter and Receiver. The transmitter (Tx) and Receiver (Rx) will already be ‘bound’ and full operating instructions for this radio set are…

13, INSTRUCTION MANUAL 13 4 Sheeted In: The end of the Mainboom should be over the inner edge of the cockpit Sheeted In: The end of the Jib Boom should be just inside the inner edge of the Gunwhale Sheeted Out: The Mainboom should sheet out to around 80º to the Hull’s centreline Sheeted…

5, INSTRUCTION MANUAL 5 1 Identify all Rudder components from the box. Note: The metal Rudder Arm is located in the fittings pack. 2 Insert Rudder into Hull. 3 Ensure the Rudder is pushed fully up into the Hull, then, pushing the Rudder Arm down, tighten the grub screw. This will locate on …