Kaiser Baas X-BEAM Complete User Manual

7, 11 12 1. Low Voltage Indicator - The red battery icon will switch on when the battery voltage reaches approximately 3.35V 2. Target Mode 3. Ambient Mode LED Indicators Attaching Your X-Beam 4. Wide Mode 5. Overheat Indicator – This icon will switch on when the temperature of the light rea…

5, Kaiser Baas X-BEAM 7 8 Ensure that your X-Beam Action Camera Light is fully charged before use. Battery Operation Removing the battery 1. Lift the clip on the top of the X-Beam Action Camera Light to reveal the battery housing. (Fig. A) 2. Slide the battery out of the housing. (Fig. B) 1. To charge your X-Beam…

6, 9 10 • Insert the battery into the light, close the housing and snap the clip closed. Refer to Fig. A and Fig. B • The On / Off switch is located on the top of the X-Beam Action Camera Light and is used to power on the device and to change the light modes. • Press and …

3, 3 4 Disclaimers & Warnings The X-Beam Action Camera Light is a high powered LED light that will get hot after extended periods of use. Exercise caution when operating the X-Beam Action Camera Light to avoid injury. WARNING: DO NOT stare directly into the light source. DO NOT use optica…

4, 5 6 Included Accessories Product Diagram Please ensure the product package has the following contents. X-Beam Action Camera Light Rechargeable 2200mAh Battery Dual Mount Screw Bolt On / O Mode Button LED Mode Indicator Short Screw Micro USB Cable Quick Release Mount Spare Rubber Seal A A E B …