Kanguru KCLONE-7HDS-PRO Operation & User’s Manual

59, Kanguru KCLONE-7HDS-PRO 59 APPENDIX A: DAISY CHAIN CONNECTION Kanguru Clone 15 target and 23 target HDD Duplicators can operate individually as standalone systems. They can also be linked together to create a system of separate HDD Duplicators working together in unison via a daisy chain connection. …

54, 54 6.5.3 Format Update Disk The Format Update Disk option allows you to format a connected SATA drive in a supported FAT32 file system. This drive can then be used to load firmware updates to the duplicator. 6.5.4 Format USB Drive The Format USB Drive option allows you to format a co…

46, 46 6.2.15 Check DC Connect (15 and 23 target duplicators only) The Check DC Connect option allows you to configure whether or not the duplicator checks for any other daisy chain connected duplicators during bootup. Tap the ‘ENT’ button to change this option. • [ ٭ ] – …

44, 44 6.2.8 Auto Kick Slow (15 and 23 target duplicators only) Not all drives are equal, and some drives will be slower than others due to max performance, health and other factors. Since the duplicator operates in a synchronous mode, the duplicator can only operate as fast as the slowest…

47, 47 6.2.18 Log Over Head Some Linux file systems uses a log-structure file system that allows for metadata to be written in between blocks of data. Normally this metadata isn’t critical and does not need to be copied. However, if you would like this information to be copied, you must d…

33, 33 6.1.8 Source Power Off The Source Power Off option allows you to configure whether the system turns off power to the Source drive after a process is completed. Tap the ‘ENT’ button to change this option’s setting. • [ ] – Source Power Off is disabled. The system w…