Kantech ioProx P600 Installation Manual

10, Installation Manual P600 ioProx Long Range Proximity Reader 10 DN5084-0804 To open the enclosure: 1. Unscrew the two screws at the bottom of the reader. Figure 2.1 - Opening the enclosure 2. Slightly open the cover from the bottom by gently prying it using a flat screwdriver at one of t…

15, Kantech ioProx P600 P600 ioProx Long Range Proximity Reader Installation Manual DN5084-0804 15 In order to install the U-bolts, you will need to drill a 5/16” (8mm) hole using the pre-positioned holes. Depending on the U-bolt used you may need to cut the length of it in order to meet the inside case room. Figure 3…

23, P600 ioProx Long Range Proximity Reader Installation Manual DN5084-0804 23 Troubleshooting Warning! Troubleshooting should be performed by qualified service personnel only. Before calling the Technical support, verify the following: Reader doesn’t read 1. Verify that no other proximity c…

4, iv DN5084-0804 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generat…

9, P600 ioProx Long Range Proximity Reader Installation Manual DN5084-0804 9 Chapter 2 • Installing the P600 Proximity Long Range Reader In choosing a location for mounting the reader, keep the following considerations in mind: no metallic and PC monitor should be near the P600 location…