Kollmorgen SERVOSTAR 300 Instruction Manual

29, 6.3 Motor holding brake A 24V / max.1.5A holding brake in the motor can be controlled directly by the amplifier. CAUTION No functional safety! Danger by falling load (in case of suspended load, vertical axes). An additional mechanical brake is required for funktional safety, which must be…

40, 6.9.8 Functional description In case of use of the STO function the input STO-Enable must be connected to the exit of a security control or a safety relay, which meets at least to therequirements of the SIL CL2 according to IEC 62061 and PL d according to ISO 13849-1 (see the connec…

48, This page has been deliberately left blank. 48 S300 Instructions Manual Mechanical Installation 02/2017 Kollmorgen …

83, Kollmorgen SERVOSTAR 300 8.12.17 ROD (AquadB) 24V (X3) Wiring of a 24V incremental encoder (ROD AquadB) as a feedback system (primary or secondary, ð p.66) using the digital inputs DIGITAL-IN 1 and 2 on connector X3. Every time the 24V auxiliary voltage is switched on, the S300 need start-up information for the posit…

104, 9.3.4 Setup Wizard The Setup Wizard leads you through the necessary steps for configuring your servo amplifier. Depending on the selected application, only the active screen pages are necessary. For a quick setup / drive test, select the setup type "Quick Motor/Drive Setup". Start the W…

27, 6.2.3 Inputs / outputs, Auxiliary voltage Interface electr. data Analog inputs 1, 2 (resolution 14/12 bit) ±10V Max. common-mode voltage ±10V Digital control inputs as per IEC 61131-2 Type 1, max. 30VDC Digital control outputs, active high open Emitter, max. 30VDC, 10mA BTB/RTO output,…