Lister A 1600-3 Manual, Operating Instruction

9, Page 9 3.5 Correct lubrication of the clipping head Lack of lubrication is the most common cause of unsatisfactory clipping results and overheating of the clipping machine. For best clipping results as well as for enhancing life time of the clipping blades and the machine, ap…

10, Page 10 4.3 Correct adjustment of the clipper blades Adjust the clipper blades as follows: When machine is switched off: Please make sure that the taper pins of the carrier fit into the holes of the upper blade (picture 4). Unscrew the counter nut anti-clockwise and tighten the adjusti…

6, Page 6 1.5 Operator responsibilities A safe use of the clipping machine only makes few demands upon the operator. Yet these are compulsory to be followed and observed: • The operator has read and understood this operating instruction, or has been instructed by an expert on the …

12, Page 12 6 REPAIRS 6.1 Introduction The measures to remedy failures are mentioned in the column REMEDY/ACTION of the list of failures. Instructions marked with * are only to be carried out by authorised qualified personnel. 6.2 List of problems In case of failures that are not li…

3, Lister A 1600-3 Page 3 1 SAFETY INSTRUCTIONS 1.1 General information These safety instructions contain basic indications to be observed during set up, operation and maintenance. All persons operating or working with the clipping machine must read these operating instructions most carefully. The op…