M/A-Com M7250 Installation Manual

52, MM-007024-001 52 16.2 REQUIRED TEST EQUIPMENT Table 16-1: Required Test Equipment TEST EQUIPMENT COMMENTS PC or Laptop PC • With Microsoft Windows ® 95 (or greater) operating system and a termi- nal application to issue commands through the COM1 serial port (such as HyperTer…

12, MM-007024-001 12 The radio provides half-duplex voice communications, and both half- and full-duplex data communications. Voice communication is accomplished via a “push-to-talk” (PTT) type microphone and a speaker connected to the mobile radio’s control head. For data communicatio…

32, M/A-Com M7250 MM-007024-001 32 2. Strip the end and connect it to the output power distribution side of the Fuse Block in accordance with the instructions included with the block. 3. Mate the DC Power Cable’s connector to the radio’s 3-pin power connector as follows: Visually align the key and fir…

45, MM-007024-001 45 13 OPTIONAL CABLES 13.1 FULL-DATA I/O OPTION CABLE The Full-Data I/O Option Cable 1000022242-0001 connects to the radio’s 44-pin I/O cable connector. It breaks out into three (3) separate D-subminiature 9-pin (DB-9) type connectors. It also has blunt-end …

14, MM-007024-001 14 4 UNPACKING AND CHECKING EQUIPMENT 4.1 MATERIALS An M7250 mobile radio installation consists of two (2) main components: • Trunk-Mount Full-Duplex 700/800 MHz Mobile Radio Unit (MRU), part number RU25011-0001 • CH-103 Control Head, part number MACDOS0003…

48, MM-007024-001 48 14 GPS NMEA-FORMATTED SERIAL DATA CONNECTION In order to obtain the GPS NMEA-formatted serial data from the radio, the Full-Data I/O Option Cable 1000022242-0001 is needed. However, the user may create a custom cable assembly that adapts to the three GPS signal…