Magma A10-701 Owner's Manual

4, OPERATING PROCEDURES OPERATE ONLY ON “LOW” WHEN LID IS CLOSED. ALWAYS OPERATE WITH GREASE TRAY IN PLACE. WARNING: Do not overheat grill. Magma Grills do not require pre-heating. Stainless Steel loses anti-corrosive characteristics when subjected to extreme heat. Most grillin…

7, 7 TROUBLE SHOOTING GUIDE Problem Burner will not light with match Flare-up Yellow sooty flame Blow-out Hot Spots Possible Cause No gas flow Obstructed gas flow Excessive cooking temperature Grease and/or residue build-up Excessive fat in meats Excessive oils in marinades Obstructed gas flow Fl…

2, IMPORTANT SAFETY WARNINGS READ ALL INSTRUCTIONS BEFORE OPERATING. 2 CONTROL VALVE REGULATOR •Uses standard 1 lb. disposable propane canisters (DOT-39 NRC). •Prior to installing valve, become familiar with the valve function & graphics on valve knob. Never force the knob. Always …

5, 5 • Inspect burner, remove any obstructions. • Clean as indicated in Maintenance (page 6). • To re-assemble, reverse the procedure above. 1. To remove radiant plate pull locking pin to release and lift plate up from left side 2. Slide plate assembly from right to left. 3. T…

8, CONTENTS LIMITED WARRANTY Magma Products, Inc. guarantees this product to be free from defects in materials or workmanship to the original consumer. This guarantee is for the periods herein specified when used under normal and reasonable conditions, one (l) year from the date of original pu…

3, Magma A10-701 3 Turbo Burner Lid Lock Oversized, Balanced Lid Grill Grates “Stay Cool” Handlei Radiant Plate Outer Shell Match Light Hole Mount Support Pad Valve Chamber Slide Out Grease Tray Control Valve Regulator Type 1 Low-Output Folding Legs MOUNT HARDWARE Fasteners are supplied for Single Mou…