MCZ Flat Use And Installation Manual

54, 52 11-PROBLEMS/CAUSES/SOLUTIONS ATTENTION! All repairs must only be carried out by a specialised technician, with the product switched o and the plug disconnected. If the product is NOT used as described in this manual, the manufacturer declines all liability for any damage caused t…

41, MCZ Flat 26 °C MAN 21:11 FR OFF 27 23:00 MAX °C 26 °C MAN 21:11 FR OFF 27 23:00 MAX °C 39 7-REMOTE CONTROL MAX Technical Dept. - All rights reserved - Reproduction is prohibited VARIOUS SETTINGS ROOM VENTILATION The room ventilation can be adjusted as desired in all 4 operating modes …

9, 7 3-INSTALLATION Technical Dept. - All rights reserved - Reproduction is prohibited FOREWORD The installation position must be chosen according to the room, to the smoke extraction system, to the chimney ue. Check with local authorities whether there are any restrictive regulati…

24, 22 6-INSTALLATION AND ASSEMBLY If you wish to connect the smoke outlet to the rear part, turn the T-tting towards the rear of the product. Then connect the pipes. TURN THE T-FITTING FOR THE REAR SMOKE OUTLET. …

22, 20 6-INSTALLATION AND ASSEMBLY Position the product without its cladding and connect it to the chimney. Once the connections are complete, assemble the cladding (ceramic or serpentine sides). If the product must be connected to an exhaust pipe that goes through the rear wall (to e…

55, 53 11-PROBLEMS/CAUSES/SOLUTIONS Technical Dept. - All rights reserved - Reproduction is prohibited ANOMALY POSSIBLE CAUSES SOLUTIONS The product works for a few minutes and then switches o. Start-up phase is not completed. Repeat start-up. Temporary power cut. Wait for the auto…