Minolta CA-210 Manual 

56, Minolta CA-210 54 7. Enter the luminescence characteristic of B and calibration values (x, y, Lv). 1 Place the measuring probe against the display, which is now emitting monochrome light of B. Currently measured values will be displayed. 2 While the probe is placed against the display, press the HOLD ke…

17, 15 Installation/Connection Switching ring About Switching Ring When you turn the switching ring, it stops at three positions (MEAS, 0-CAL, POINTER). To turn the ring, the stopper must be pulled toward you to unlock it. MEAS : To perform measurement, the ring must be set in this pos…

76, 74 Measurement Before starting measurement, perform the following. 1. Performing Measurement [Measuring Method] 1. Press the MEMORY CH and keys. keys to select the memory channel for which user calibration has been performed (page 49), the RGB luminescence characteris- tic for analyze…

83, 81 Measurement Section 7. Adjust the white balance. Normally, white balance can be adjusted by performing cutoff and drive adjustment for the display. In this section, the method of adjusting the display’s color to the target color (W) is explained. The method is explained by taking the followin…

22, 20 3 Analog display section ............................ Displays the difference (%) between the measured value and the tar- get color or the difference (%) between measured values. The range for each dot can be set between 0.1 and 99%. (Page 67) ● How to read/when the range is set i…

66, 6464 3. Enter target color values (x, y, Lv). For x and y, a value 10000 times the calibration value must be entered. Use the ten-key ( to , ) to enter the value. The cursor moves to the right each time a value is entered. Each time the key is pressed, the cursor moves in the order x�…