Monarch Nova-Strobe bax Instruction Manual

18, CE DECLARATION OF CONFORMITY As Manufacturer: Monarch Instrument Division of Monarch International Inc. 15 Columbia Drive, Amherst NH 03031 USA declares under Monarch’s sole responsibility that the product: to which this declaration relates is in conformity with the following sta…

11, E-7 while pushing it into place (see Figure 4). Make sure the lamp is in straight and centered in the reflector hole. CAUTION: Do NOT allow the reflector to contact the lamp. 4. Reinstall the reflector and then position the front lens in place matching up the notches on the lens with the two s…

7, Monarch Nova-Strobe bax E-3 quickly turn the knob (or use the x2 or ÷2 buttons) to coarsely change the FPM. Then slowly turn the knob for fine adjustments. NOTE: There are maximum and minimum values in each mode beyond which you cannot adjust. If you are adjusting the rate and you reach a value which on t…

8, E-4 4.0 USING THE STROBOSCOPE TO MEASURE RPM The primary use for a stroboscope is to stop motion for diagnostic inspection purposes. However the stroboscope can be used to measure speed (in RPM / RPS). In order to do this several factors need to be considered. First, the object being measured…

4, TABLE OF CONTENTS TABLE OF CONTENTS 1.0 OVERVIEW .......................................................................... E-1 1.1 Display Panel / Definition of Buttons ........................ E-1 2.0 PREPARATION FOR USE ..................................................... E-2 2.1 Power........…

9, E-5 Example: object rotating at 2500 RPM If the speed is outside the full scale range of the stroboscope (10,000 FPM), it can be measured using the method of harmonics and multipoint calculation. Start at the highest flash rate and adjust the flash rate down. You will encounter multiple images so be…