Motorline ROSSO EVO User And Installation Manual

7, AUTOMATISM INSTALLATION  AUTOMATISM INSTALLATION 04. INSTALLATION 04. INSTALLATION 06.A 06.B 04 - Raise up the motor until the rail is levelled horizontally. If necessary, you should create a support structure to a solid surface as shown on the previous page, so that the ra…

9,  Programming opening and closing courses  Press the M key for  seconds to enter the programming menu.  The display will show P and press the M key for sec to enter the submenu.  The display will show OP and you can now set the opening limi…

6, AUTOMATISM INSTALLATION  FIXING THE MOTOR IN RAILS 04. INSTALLATION 04. INSTALLATION 01 - The steel rail and automatism attachment must be made using the plates and M6 nuts as shown above. Fasten 4 screws, leaving the two in the middle free. 02 - The aluminum rail and automatism atta…

5, Motorline ROSSO EVO INFORMATION PRE-INSTALLATION  CHANGING COURTESY LEDS CHANGING FUSE 03. THE AUTOMATISM 04. INSTALLATION For a correct operation of ROSSO EVO, you must take into account the following parameters before the installation:  Read all steps on this manual at least once in order to get acqua…

11, MENU FUNCTIONS  MENU FUNCTIONS 05. PROGRAMMING 05. PROGRAMMING  Programming maintenance warnings  Press the M key for  seconds to enter the programming menu.  The display will show P and press and keys repeatedly until it shows P.  Pres…

12, The automatism needs a stopper in the opening and closing to always control the courses. In closing maneuvers, the ground will be the stopper for the gate, but in the opening maneuvers it is necessary to create a stopper on the steel rail, to ensure that the trolley always stop in the corre…