Amprobe AT-4000 Operation & User’s Manual

19, T-4000 R-4000 B2024 17 Locating Outlets From The Breakers Panel 1. Connect the A2202 Clamp-on to the T-4000 Transmitter and then clamp it around the conductor. 2. Set the T-4000 to ‘HIGH’ signal level. 3. Set the R-4000 to ‘OPEN’ mode and ‘LOW’ sensitivity. 4. Hold the R-4000 in …

18, 16 Tracing Energized Wires 1. Connect the Alligator Clip Cord set to the T-4000. 2. Make sure the voltage does not exceed the T-4000 rating. 3. Connect one alligator clip to the hot wire and the other to a separate ground.At a receptacle, use the C2901 Pigtail to access the hot wi…

21, REPLACEMENT PARTS 9V Battery.................................................................................................9V Alkaline Clamp-On Transmitter Accessory..............................................................A2202 Battery Pack..................................…

17, 15 Tracing Wires in Conduit When seeking a ground fault within metal conduit, the ‘ground’ is the conduit. Connect one of the clips to the conduit to complete the circuit. Steel conduit will tend to attenuate the signal strength so tracing will require higher sensi- tivity levels and access to …

20, Amprobe AT-4000 MAINTENANCE Changing Batteries The battery compartment on the back of the R-4000 and the T-4000 is designed to make it easy for the user to change the battery.A screw is added to secure the battery in case the unit is dropped.A 9-Volt battery is used. Fig.21 9V Battery 1. Remove the battery cover. …