Artel PCS Quick Start Manual

6, Consumable Components Vial Cleaning To ensure accurate results, all vials should be free of fingerprints and smudges prior to placing in the vial block for equilibration. All vials should be cleaned prior to use. • Holding the vial by the cap, immerse the lower portion of the vial (about 2.5 cm) …

9, Always refer to the PCS Procedure Guide for further instruction Important Notes: • Use the CAL A vial from the Reagent Kit and not from the Instrument Calibrator Kit. • Never remove the cover of the CAL A vial. • The label for the CAL A vial should face the front of the Instrument with …

12, Aspirating and Dispensing Sample Solution Using a plastic transfer pipette, transfer an aliquot of Sample Solution into an aliquot container. Both items are located in the Reagent Kit. Transfer only enough solution for half-hour increments. The volume gradations on the transfer pipette …

11, Artel PCS Always refer to the PCS Procedure Guide for further instruction Important Notes: • The proper range of Sample Solution for the pipette volume to be tested must be used. • Each Reagent Kit contains bottles of Sample Solution corresponding to various pipette volume ranges. • If an improper Sampl…

5, Always refer to the PCS Procedure Guide for further instruction Seiko Printer Loading the Printer Paper: • Turn the power switch to the ON position. • Open the paper cover located on the top, right side of the printer. • Cut the end of the paper roll cleanly and squarely. • Inse…

14, Reprint Results? (Yes/No) Delete Data Points? (Yes/No) Enter Pt # to Delete • If, at the end of the run, a second copy of the results is desired, press YES at the next prompt (Figure 14). • If it is determined that a given data point may be eliminated from the statistical ca…