EarthCore ECO-Steel Manual, Installation And Maintenance Instruction

2, 2 CHIMNEY DIAMETER: Follow the replace manufacturer’s manual to determine required chimney diameter and clearances between combustible materials and your replace. Never use a chimney with an inside diameter smaller than your rebox ue opening unless specica…

6, 6 Elbow Installation: 15° and 30° elbows are provided to allow chimneys to avoid framing members or roof peaks. A maximum of 30° from vertical is allowed and a total of two elbows for each chimney installation. A 2” clearance to combustibles must be maintained. If…

5, 5 For chase enclosures, install the chase top cover (supplied by others) to the chase enclosure. Cut a hole in the chase top cover the same diameter as the base of the cone on the ashing. Attach the Flashing to the top of the chase cover, sealing with a non-hardening wate…

3, EarthCore ECO-Steel 3 Mark appropriate cutting lines around the center point. Cut a square hole in the ceiling. Frame a level, square opening centered over the hole that you have cut. Frame openings at each oor level above the replace. See FIG. 3. These openings are to hold the Firestop and …

4, 4 FIG. 5 FIG. 6 Cut Roof Opening: If penetrating through the roof, determine and cut an opening in the roof directly above the opening below. The cut opening must be 4 inches larger than the chimney’s outside diameter to provide at least a 2 inch clearance all around the chim…

8, 8 13ACECO6 & 13INECO6 6” Pipe 6899 Phillips Industrial Blvd.● Jacksonville, FL., 32256 (800) 642-2920 ● Fax (904) 363-3408 Chimney Solutions ECO-Steel COMPONENT LIST With Part Numbers 13ACECO12 & 13INECO12 12” Pipe 13ACECO18 & 13INECO18 18” Pipe 13ACECO36 &…