Ampro Corporation ReadyBoard 700 Reference Manual

73, Chapter 4 BIOS Setup ReadyBoard 700 Reference Manual 67 ♦ PnP OS – [Disabled] or [Enabled] If this field is set to [Enabled], the BIOS makes the Plug and Play API available for Plug and Play Operating Systems. This allows the Plug and Play OS to get the Plug and Play informat…

23, Chapter 2 Product Overview ReadyBoard 700 Reference Manual 17 Thermal/Cooling Requirements The CPU, Northbridge, Southbridge, Secondary I/O, and voltage regulators are the sources of heat on the board. The ReadyBoard 700 is designed to operate at its maximum CPU speed of 400MHz, 650M…

30, Ampro Corporation ReadyBoard 700 Chapter 3 Hardware 24 Reference Manual ReadyBoard 700 Pin # Signal Input/ Output Description 20 (A20) GND Digital Ground 21 (A21) AD29 T/S PCI Address and Data Bus Line 29 – Refer to Pin-3 for more information. 22 (A22) +5V +5 volt power supply ±5% 23 (A23) REQ0* T/S Bus Request 0 – This …

65, Chapter 4 BIOS Setup ReadyBoard 700 Reference Manual 59 Table 4-2. Floppy Drive BIOS Settings # of Floppy Drive(s) BIOS Settings None • Set Drives A and B to [None] (1) Non-USB Floppy* • Configure Drive A to floppy drive type (For example, [1.44MB, 3.5”] ) • Set Drive …

54, Chapter 3 Hardware 48 Reference Manual ReadyBoard 700 Pin # Signal Description 39 FPDEN Flat Panel Data Enable – This signal to settle the horizontal display position. 40 FP0 Flat Panel Data Output 0 – Refer to pin-2 for more information. 41 FPCLKS Flat Panel Shift clock – This…