Baumer VCXG .I Operation & User’s Manual

49, 49 6.3 Acquisition Modes and Timings The image acquisition consists of two separate, successively processed components. Exposing the pixels on the photosensitive surface of the sensor is only the rst part of the  image acquisition. After completion�…

52, Baumer VCXG .I 52 6.3.5.1 Overlapped Operation: t exposure(n+2) = t exposure(n+1) In overlapped operation attention should be paid to the time interval where the camera is unable to process occuring trigger signals (t notready ). This interval is situated between two  exposures. When this…

87, 87 7.6 Process Interface 7.6.1 Digital-IOs 7.6.1.1 User Denable Inputs The wiring of these input connectors is the responsibility of the user. The sole exception to this is the compliance with predetermined high and low levels (only the optical input IN1; 0 ... 4.5V low,�…

31, 31 5.1.2 Power Supply and IOs Power Supply / Digital-IOs (on camera side) wire colors of the connecting cable (ordered separately) 8 5 7 3 1 4 2 6 1 GPIO (Line2) white 5 Power V CC OUT1 grey 2 Power V CC brown 6 OUT1 (Line3) pink 3 IN1 (Line0) green 7 GND (Power, GPIO) blue …

95, 95 7.6.5 ExposureActive (Flash Signal) This signal is managed by exposure of the sensor. Furthermore, the falling edge of the ExposureActive signal can be used to trigger a move- ment of the inspected objects. Due to this fact, the span time used for the sensor readout t readout can be used opt…