Bentel Security FireClass 200 Installation Manual

16, Power unit The FireClass200 is available in two models: FC200/S - with 27.6 V - 2.5 A Switching power supply (see fig. 3a); FC200 - with 27.6 V - 4 A Linear po- wer supply (see fig. 3b). PART DESCRIPTION 24 Rivet to secure switching power supply 25 Power supply protection fuse: a) F3.15A 250V; b…

61, Timer and Special timer Sensors are particularly sensitive, therefore, when persons are present in the protected ambient the Alarm Threshold must be increased by the non- modifiable Default value (to allow for cigarette smoke etc.). The Timer and Special Timer can be programmed to control the …

30, Bentel Security FireClass 200 Connection of Output Devices The control panel has 2 Non-monitored outputs, 4 Bell Outputs (Monitored) and 8 Alarm Repetition Outputs (one for each Software Zone) for the con- nection of Output Devices. The Bell Outputs can be expanded to 10 or 16 by means of one or two FC200/6OUT Output Ex…

70, Network When the Fire control system is fully installed, and several control panels are connected via RS485: one of the control panels must be programmed as MASTER and all the others as SLAVES. Select the NET option from the SYSTEM menu to program the MASTER and SLAVES. It is possible to conn…

26, Connection of Addressable Analogue Devices The control panel has 2 Loops for the connection of Addressable Analogue Devices. Each Loop allows for the connection of up to 99 Addressable Analogue Fire Detectors and up to 99 Analogue Devices (Monitoring Modules, Con- ventional Zone Modules, Co…