Aurora Audio Sidecar Manual 

21, See graph below for output levels versus headphone impedance. Three illumination push buttons are provided for monitor options :- 1. Cut (Red switch) fully mutes both stereo paths so no signal reaches the monitor speakers. 2. Alt LS (Green switch) switches between two sets of moni…

17, Addendum #1 :- Using Channel and Output Pre-fade insertions. An optional feature for the Audio Sidecar, which can be factory or distributor retro fitted, is line level and balance pre fade insertions for the channels and 2T bus outputs. These involve fitting a new, hinged, rear panel tha…

8, Aurora Audio Sidecar Bus Sends, Pan-Pot Controls, And Cut Switch: The pan-pot is only in line when both Left and Right bus assign buttons are pressed. The green “Pan” LED will illuminate to confirm that the pan-pot is in line and the pan control can now be turned to place the sound in the required …

15, Specifications: Channels Gain :- -10dB to +80dB on the input sensitivity switch plus another 10dB in the fader. Input Impedance :- 1.2Kohm (XLR I/P), 10Mohm (DI I/P) Output Impedance :- < 50 ohms balanced VU Meter range :- Standard VU points from -20VU to +3VU where 0VU = +…

16, Warranty: ONE YEAR PARTS AND LABOR LIMITED WARRANTY Aurora Audio International warrants this Aurora Sidecar unit against defects in workmanship for a period of one year and parts for a period of one year from receipt by the original end user. This warranty shall not apply to damage resultin…