Auto Meter DM-46 Instruction Manual

1, DM-46 Instruction Manual Automotive Multimeter and Inductive Amp Probe The DM-46 is the auto industry’s answer to pocket portability in a professionally accurate meter.2650-1910-77 11/9/16 Auto Meter Products Inc. 413 West Elm Street Sycamore, IL 60178 Service (815) 899-0801 Toll Free …

5, CONTROLS AND FUNCTIONS 7. VΩRANGE Zero/Relative Button. On voltage or ohm function, press this button to select manual range. On other functions, once this button is pressed, the current reading shall be set to zero and be used as a zero reference value for all other subsequent measur…

8, Auto Meter DM-46 CAPACITANCE and TEMPERATURE DIODE TEST 1. Plug the adapter into the terminal. 2. Insert the the capacitor into the adapter. 3. If the capacitance is less than 4nF press zero (capacitance) button to zero the residual capacitance. 4. Read the capacitance from the LCD. TEMPERATURE …

9, RESISTANCE MEASUREMENT 1. Set the rotary switch to Ω. 2. Insert the test leads into the input jack. 3. Connect the test probes of the test leads to the two ends of the resistor or circuit to be measured. 4. Read the measured value from the LCD. CONTINUITY TEST WARNING: Bef…

6, 1. Set the rotary switch at 40A or 200A and move the sliding switch to DC. 2. Push the zero button to zero reading the Amp reading. 3. Press the trigger to open the jaw and fully enclose the conducting wire to be measured. Be sure there is no air gap between the two half jaws. 4. …