CEL-MAR ADA-14040 Operation & User’s Manual

21, 5.2.2.1.3.2. UDP CLIENT & SERVER CONFIGURATION IN CASE OF SLAVE DEVICE Set operating parameters of UDP server for SLAVE device connected via serial port to ADA-14040, eg like on picture below. Set an access to UDP server on e.g. 2101 port. Then select Automat…

26, Attention ! Default port of Industrial Automation (Modbus Gateway) is 502. If on the local network conflict with other network service using the same port, change number of port into another for the service server of serial bridge and client in the server port configuration. On section Advanced…

31, 9. VERSIONS ADA-14040 - - - Order example: Product Symbol: ADA-14040-1-2-3 1 – basic version of electronic, 2 - galvanic isolation 2kV= (2-way), 3 - cover without inlets, plug-in screw terminal block, Electronic versions: Basic 1 Galvanic isolation: 1kV DC (2-WAY) 2 3kV DC (2-WAY) 3 T…

20, 5.2.2.1.2.3. SERIAL PORT TRANSMISSION PARAMETERS For proper operation of ADA-14040 with device connected to his serial port, should be set the same transmission parameters for both devices. Select Basic Serial Settings and enter Baud Rate, Data Bits, Parity, Stop Bits, the same pa…

9, 3.2.4. CONNECTION FOR FUNCTIONING IN MODE TCP/UDP SERIAL BRIDGE Figures below show correct connection of ADA-14040 to wireless network and INTERNET network to functioning in TCP serial bridge mode or UDP. Fig 7. Connection to functioning in TCP/UDP serial bridge mode, one-to-one in LAN network…

24, CEL-MAR ADA-14040 Fig 27. Example configuration for communication with MODBUS-MASTER devices - type of devices and protocol Next section is Advanced Protocol Settings (fig. below), set the time outs : - Character timeout - value in ms., maximum delay or gap betweens bytes of a message – default 20 …