CEM iLDM-30 Operation & User’s Manual

11, Laser Distance Meter User Manual 11 Figure E MIN MAX .4 Measuring Press again to trigger the distance measurement. The measured value is displayed immediately. The continuous measurement function (tracking) is used for the transferring of measurements, e.g., from construction plans. In…

6, 1) Remove battery compartment lid. 2) Insert batteries, observing correct polarity. 3) Close the battery compartment again. Replace the batteries when the symbol “ “ flashes permanently in the display. • Use alkaline batteries only. • Remove the batteries before any long perio…

8, Laser Distance Meter User Manual 8 LCD Display (See “figure C”) 1- Laser active 2- Reference level (front) 3- Reference level (rear) 4- Battery status 5- Intermediate line 1 6- Intermediate line 2 7- Summary line Figure C 1 2 3 4 5 6 7 …

5, Laser Classification There is a visible laser beam which emerges from the front of the instrument. Do not stare into the laser beam or direct it towards other people unnecessarily. Eye‘s protection is normally afforded by aversion responses including the blink reflex. Looking d…

13, Laser Distance Meter User Manual 13 Whilst the first connection between the Phone/PC and the Laser distance meter is being established, a prompt for the Pin-code of the instrument may be displayed. In this case, enter the code 0000 into your Phone/PC. Press and hold Func/Unit button until …

7, CEM iLDM-30 Keypad (See “Figure B”) 1- button 2- button 3- button 4- Button ON/MEAS CLR/OFF MEM/Reference Function( )/Unit Laser Distance Meter User Manual 7 OFF MEM Uint Figure B 1 2 4 3 …