Encore Networks EN-2000 Reference Manual

8, Page 10-8 EN-2000™ Reference Manual, Document 10 Go to Table of Contents Figure 10-9. Advanced Firewall Settings Screen for the WAN Zone of the VPN Tunnel Initiator d On the Advanced Firewall Settings Screen for the WAN Zone of the VPN Tunnel Initiator, specify !f.g.h.i/j in the field Restrict …

2, Page 10-2 EN-2000™ Reference Manual, Document 10 Go to Table of Contents Figure 10-1. Firewall Zone Settings Screen for the IPsec VPN Tunnel Responder 2 For this example, select the Edit button in the row for the WAN zone. Note: In general, select the Edit button for each zone for which Masqu…

5, Configuring the EN-2000’s VPN Firewall Page 10-5 Go to Table of Contents 9 On that screen, make sure the following settings are observed: • Under the heading General Settings: ◆ Select Enable SYN-Flood Protection. ◆ Select Drop Invalid Packets. ◆ Set Input as Accept. ◆…

7, Configuring the EN-2000’s VPN Firewall Page 10-7 Go to Table of Contents Figure 10-7. IPsec VPN Tunnel Screen for a VPN Tunnel Initiator Right Subnet Not 0.0.0.0/0 a Select the Network tab; then select the Firewall tab. ❖ The Firewall Zone Settings Screen for the IPsec VPN Tunn…

3, Encore Networks EN-2000 Configuring the EN-2000’s VPN Firewall Page 10-3 Go to Table of Contents 3 On the General Firewall Settings Screen for the WAN Zone of the VPN Tunnel Responder, configure the following: • Under the heading General Settings: ◆ Set Input to Reject. ◆ Set Output to Accept. ◆ Set For…

13, Configuring the EN-2000’s VPN Firewall Page 10-13 Go to Table of Contents Figure 10-15. VPN Responder’s Firewall Traffic Rules Screen for a Source NAT 4 On that screen, make sure the following values are entered: • Protocol: All protocols • Source zone: LAN • Source…