Factor ONE Disc Assembly Manual

5, Assembly Manual 01 Necessary tools Instructions 1-1 Torque wrench with 2.5, 3, 4, 5mm hex & Torx T20 bits BRT-002 bearing press from Enduro Bearings Sand paper (120-180 grit) Park Tool IR-1 Grease & Loctite 243 & 641 Isopropyl alcohol Seatpost 1-2 1-3 Adjust the set back and saddl…

14, Factor ONE Disc Assembly Manual 10 DISC Apply Loctite 243 on bolt threads. Thread the bolt in but do not tighten, this will allow the insert to align when installing the axle Remove the thru-axle and remove the hub. Install the rear wheel and tighten the thru-axle (with the nylon washer) to 12Nm. Install…

3, Congratulations on the purchase of your FACTOR product. Please review thoroughly the following instructions and only follow them for correct operation and use. Should you fail to follow the following instructions and warnings, this could result in damage of the product, damage to the bicycle and …

9, 3-5 Assembly Manual 05 3-3 3-4 Route the front derailleur Di2 cable through the seat tube hole to the bottom bracket exit port. Install Di2 cable grommet. Install Di2 cable grommet. 3-6 Connect to the Di2 Junction B. Install Di2 cable grommet. Route the rear derailleur Di2 cable through the cha…

10, 3-93-83-7 Route the Di2 Shifter cable from the Junction B through the down tube, until it exits the head tube. Assembly Manual 06 DISC Cut the cable housing to the correct length Fork 3-10 3-11 3-12 Lightly grease and install upper headset bearing as pictured Lightly grease and install hea…