Flowserve HSH Series Installation Instructions Manual

8, TO REORDER REFER TO B/M # F.O . FIS230eng ORG 08/16 Printed in USA Flowserve Corporation has established industry leadership in the design and manufacture of its products. When properly selected, this Flowserve product is designed to perform its intended function safely during its …

6, Flowserve HSH Series 6 6 Performance Testing of Pumps Pump manufacturers will often perform pump performance tests on water with the mechanical seal installed. If the pump product used during field operation is not equal to water, seal designs and face materials requir…

4, 4 3 Shrink disk drive collar installation A shrink disc drive collar may be supplied as a sub-assembly loosely installed on the non-wetted end of the seal sleeve or separately packaged with the seal. The shrink disc bolting should be in place, but loose. Note that shrink disc drive…

2, 2 Shaft runout should be checked against the equipment manufacturer‘s specifications. Generally, should not exceed 0.05 mm (0.002 inch) TIR (Total Indicator Reading) at any point along the shaft for ball or roller type bearings. For sleeve type bearings, refer to…

3, 3 2 Cartridge Seal Installation For proper seal installation, you must obtain the correct seal assembly drawing for your application. 2.1 Lubricate the shaft or sleeve lightly with lubricant provided with the seal. 2.2 Install gland gasket - Use lubricant provided if necessary to retai…

1, Installation Instructions HSH Series Balanced high pressure pusher seals Experience In Motion 1 Equipment Check 1.1 Follow plant safety regulations prior to equipment disassembly: 1.1.1 Wear designated personal safety equipment 1.1.2 Isolate equipment and relieve any pr…