Flowserve CBR Series Installation Instructions Manual

8, Flowserve CBR Series flowserve.com TO REORDER REFER TO B/M # F.O . To find your local Flowserve representative and find out more about Flowserve Corporation, visit www.flowserve.com FIS117eng REV 09/2018 Printed in USA Flowserve Corporation has established industry leadership in the design and manufacture …

2, 2 1 Equipment Check 1.1 Follow plant safety regulations prior to equipment disassembly: • lock out motor and valves. • wear designated personal safety equipment. • relieve any pressure in system. • consult plant MSDS les for hazardous material regulatio…

6, 6 2.12 Position the gland to the face of the seal housing. Be sure the gland pilot is properly engaged. Tighten the gland stud nuts evenly, cross stagger the adjustment of the nuts. Excessive gland bolt tightening can result in distortion of the stationary face. 2.13 See …

7, 7 5 Repair This product is a precision sealing device. The design and dimension tolerances are critical to seal performance. Only parts supplied by Flowserve should be used to repair a seal. To order replacement parts, refer to the part code and B/M number. A spare backup seal shoul…

5, 5 2.2 Scribe mark B, Figure 1, at the seal setting point shown on the assembly drawing included with the seal. (This is the seal setting dimension as measured from the face of the seal housing to the back of the bellows drive collar. The back of the bellows drive collar will be located at…