Duplo DSF-2000 Maintenance Manual

41, 2-8 99T-M12M0-0107-0 1-31. Power Supply Inlet Incorporated in the remote unit. Connected to the power cord. 1-32. IF Cable Interface cable for communication with the downstream processing unit. Be sure to use the specified cable. 1-33. Power Cord Supplies primary power to the machi…

10, 1-7 99T-M12M0-0107-0 2-3. Solenoid Valve The valve is used to switch the suction box to the suction/release state. Use the DC solenoid to switch the suction/release state. A large square hole is on the bottom of the suction box. The suction/release state is set by opening and closing the hole with t…

47, Duplo DSF-2000 2-14 99T-M12M0-0107-0 3-9. Feed Speed Setting Turn the jog dial to display “Feed Speed”, and press the jog dial. Turn the jog dial to set the paper feed speed. 3-10. Double-feed Sensor Data Mode This mode can be used to set the light volume when the paper thickness to be detected is set to …

21, 1-18 99T-M12M0-0107-0 5-3. Adjusting the Gate Solenoid and Stopper Perform the adjustment while checking the gate through the peeping hole at the frame F side. Adjustment of solenoid ON state Adjust the attaching position of the solenoid so that the clearance between the tip of th…

18, 1-15 99T-M12M0-0107-0 5. REVERSAL SECTION Gate Reversal sensors Reversal roller 1 Reversal roller 2 Reversal auxiliary guide Solenoid Reversal counter Stopper …

39, 2-6 99T-M12M0-0107-0 1-11. Paper Feed Tray A (B) Suction Valve Solenoid Solenoid for driving the suction valve. Uses a DC +24 V power. 1-12. Reversal Switching Solenoid Solenoid for driving the reversal switching section. Uses a DC +24 V power. 1-13. Reversal Clutch 1 (2) Electromagnetic clutch…