BitaTek IT7000 Operation & User’s Manual

22, 2.4.2 Power (and Backlight) on / off  To turn on the PDA Press the Power/Backlight key briefly ( ). If the PDA does not power on, perform the cold reset. See chapter 2.7.1. As the PDA initializes its File system, the IT7000 splash screen displays for about 30 seconds follow…

37, Figure 2-16-3 Figure 2-16-4 2.5.7: Scanning Barcode: To use the scanning function, complete the following steps: 1. If you have not already done so, remove the protective plastic film before using devices equipped with a laser scanner. …

39, BitaTek IT7000 2.6 Power management 2.6.1 Suspend Mode The PDA will go into a suspend mode when it is idle for a period of time. The idle duration can be customized using the Power control panel (refer to Figure “Schemes Tab”) Suspend mode works and looks just like you have turned the unit o…

38, 7.Barcode Scanning Position This device can read from 40 to 300mm distance. 1) Position the laser scanner close to the barcode when scanning small barcodes. And position it is a distance from the barcode when scanning large barcodes 2) The reader can be detected by a red beam. …

34, 2.5: Navigating the Display 2.5.1: Setting Time and Date: Figure 2-14 Date/Time properties 4. To change the time, select the hour, minute, seconds, or AM/PM and select the up arrow to increase the value; select /tape the down arrow to decrease the va…