Composite-ARF Edge 540 2.6m Assembly Manual

2, 2 | Page Edge 540/2.6m Congratulations on acquiring your new Composite Arf 2.6m Edge 540! Here at Composite Arf we endeavour to bring you the best model aircraft possible, built with modern and innovative techniques. The Edge 540 is constructed using our revolutionary Total Area Vacuum Sandwich (TA…

32, 32 |Page Edge 540/2.6m To ventilate the fuselage you will need to cut some cooling slots. The fuselage material is easy to cut out, using your Dremel. Finishing with a sanding drum will keep the process simple and tidy. Where you place the slots is again dependent on the final fit out and com…

34, 34 |Page Edge 540/2.6m This is an option that can only be done if you have elected to glue in place the battery/ignition tray as previously described earlier in the manual. If you are not using this tray cutting access is not an option! Having the tray glued in place significantly in…

27, Composite-ARF Edge 540 2.6m 27 |Page Edge 540/2.6m When you are satisfied that the cable exit slot is positioned correctly, make a cut with your Dremel and cut off wheel. The cut off wheel will cut the fuselage material with ease, so keep the tool steady. You should now make up your pull/pull cables. Start by doing one…

12, 12 |Page Edge 540/2.6m Parts Required: § Cowl Assembly § Fuselage Parts Bag § Standoffs. 2 SWB adjustable stand offs Tools Required: § Electric Drill § Drill Bit  various § Square (rule) § Steel rule(s) § Level § Masking tape § Marking pen The engine installation req…