Brocade Communications Systems X6-8 Hardware Installation Manual

191, 2. Perform one of the following steps: • If you need to power down the chassis to remove a fan assembly, enter the sysShutdown command. When command output indicates the chassis has completed shut-down, remove power cords from all power supply assemblies. • If you can hot-swap the fan …

141, Verifying blade operation Perform the following tasks to verify operation of new blade: 1. Check the LED indicators on the blade's front panel. For information on interpreting LED patterns, refer to Interpreting core routing blade LEDs on page 91. Enter the slotShow command and …

176, Power supply assembly numbering The following gure illustrates the location and number identication of power supply assemblies in the chassis. FIGURE 51 AC Power supply assembly numbering 1. Power supply 1 2. Power supply 2 3. Power supply 3 4. Power supply 4 FIGURE 52 HVAC/H…

33, FIGURE 3 14U rack kit parts 1. Left rack mount shelf bracket 2. Right rack mount shelf bracket 3. 10-32 x 5/8 in. (1.58 cm) panhead Phillips screw and washer 4. 10-32 clip nut for cabinets that have rails with round holes 5. 1/4-20 x 1/2 in. (1.27 cm) panhead Phillips screw with lock washer for cabi…

209, Brocade Communications Systems X6-8 Disconnecting from network and fabric Complete the following steps to disconnect the chassis from the network. 1. Shut down the device using the sysShutdown command on the active CP blade. switch:admin> sysshutdown This command will shutdown the operating systems on your switch. You…

182, 2. Grasp the handle and slide the new power supply into the chassis while supporting the power supply from beneath. Push the power supply into slot until the connectors seat in the chassis backplane. 3. Verify that the power supply assembly is seated by gently pushing on the handle. 4. Push in ca…