HEIDENHAIN 548431-05 Operation & User’s Manual

333, Teach-in | Thread and undercut cycles 5 HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017 333 GV: Type of infeed Further information: "GV parameter: Type of infeed", Page 313 0: Const. mach. X-section 1: Const. infeed 2: EPL with distrib. of cuts 3: EPL w/o dis…

418, ICP programming | ICP contours 6 418 HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017 Machining attributes You can assign the following machining attributes to the contour elements. Machining attributes: U: Oversz additive to other oversizes ICP generates a G52 Pxx H1. F: …

466, ICP programming | Contour elements on lateral surface 6 466 HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017 Basic elements of lateral surface Starting point of lateral surface contour Enter the coordinates for the starting point and target point in the first contour e…

684, Tables and overviews 10 684 HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017 Q = 17 NPTF US taper dryseal pipe thread Thread designation Diameter (in mm) Thread pitch 1/16'' 7.938 0.94074074 1/8'' 10.287 0.94074074 1/4'' 13.716 1.411111111 3/8…

33, Contents HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017 33 6 ICP programming..........................................................................................................................415 6.1 ICP contours..........................................................…

149, HEIDENHAIN 548431-05 Machine mode of operation | Program run submode 4 HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017 149 Variables Refer to your machine manual. This feature must be enabled and adapted by the machine tool builder. In Program run submode, it is possible to display and edit t…