Jasic MIG 350 Pulse Separate Operator's Manual

29, Jasic MIG 350 Pulse Separate WWW.JASIC.CO.UK 29 Troubleshoong in MIG/MAG Malfuncon phenomena Cause analysis Soluon The robot cannot com- municate with the weld- ing source. The control cable is unconnected. Connect the control cable. The control cable is not well connected. Reconnect the control cable. T…

18, WWW.JASIC.CO.UK 18 Parameters in MMA There are 5 adjustable parameters in MMA welding, namely arc ignion current, arc ignion me, arc current, arc characterisc (arc force) and arc breaking voltage. The…

23, WWW.JASIC.CO.UK 23 For most of the parameters in double pulse MIG/MAG, see the contents of the MIG/MAG secon for reference. And the unique parameters in double pulse MIG/MAG are especially described as below combined with Figure 1 LF peak current It is located at “pea…

13, WWW.JASIC.CO.UK 13 Details of the funconal zones on the power supply control panel Welding mode selecon This area contains components such as welding mode LEDs and the selecng key. There are 4 welding modes, namely standard MIG/MAG, pulsed MIG/MAG, Double pulse MIG/MAG a…

3, WWW.JASIC.CO.UK 3 SAFETY These general safety norms cover both arc welding machines and plasma cung machines unless otherwise noted. The equipment must only be used for the purpose it was designed for. Using it in any other way could result in da…