JDS Uniphase 4100 Operation & User’s Manual

159, Chapter 9 File management Explorer Function User Manual 770000102/08 139 According to the application selected, the fiber information available are different. The table below describes the fiber information displayed for each selected tab: Editing function The same editing functions as those from…

137, Chapter 8 FiberComplete Modules Performing the tests User Manual 770000102/08 117 1 Press FILE hard key 2 Select Explorer page 3 Select the configuration file in the wished directory. 4 Press Load > Load Config. – Press S ETUP hard key to display the OTDR and FCOMP acquisition paramet…

140, Chapter 8 FiberComplete Modules Results screen 120 User Manual 770000102/08 The Cable View allows to display results of multiple fibers: – the average loss at each wavelength – the ORL A and ORL B at each wavelength – the distance is displayed on top of the screen Fiber View …

169, Chapter 10 Technical specifications Technical specifications of the Source function on module User Manual 770000102/08 149 Power meter option for Multi/Single mode Modules Technical specifications of the Source function on module – Laser Class 1 – Wavelength lasers at 25°C, depen…

42, JDS Uniphase 4100 Chapter 4 Configuring the reflectometry test Configuring the test in OTDR Expert 22 User Manual 770000102/08 Resolution This parameter is exclusively configurable if Acquisition parameter is set to Manual. Auto resolution is selected automatically according to the last two parameters above. High R…

129, Chapter 8 FiberComplete Modules Establishing References User Manual 770000102/08 109 Loopback Referencing method The loopback referencing is used when the two units are at different loca- tion. After clicking on Loopback, the wizard will guide you through two steps: 1 The self re…