HOLT ADK-5200 Quick Start Manual

8, QSG-5200 8 Holt Integrated Circuits J1 Pin # Signal J1 Pin # Signal 43 +5V 44 +5V 45 -- 46 -- 47 -- 48 -- 49 -- 50 -- …

3, QSG-5200 3 Holt Integrated Circuits Introduction The Holt HI-5200 is a 10Base-T/100Base-TX physical layer transceiver with both MII and RMII MAC interfaces. It utilizes a unique mixed-signal design to extend signaling distance while reducing power consumption, and offers H…

6, QSG-5200 6 Holt Integrated Circuits J1 Pin # Signal J1 Pin # Signal 29 TXEN 30 GND 31 TXD0 32 GND 33 TXD1 34 GND 35 TXD2 36 GND 37 TXD3 38 GND 39 COL 40 GND 41 CRS 42 GND 43 +5V 44 +5V 45 -- …

1, HOLT ADK-5200 QSG-5200 Rev. A Holt Integrated Circuits ADK-5200 Quick Start Guide: HI-5200 10Base-T/100Base-TX Physical Layer Transceiver April 2018 …

12, QSG-5200 12 Holt Integrated Circuits LED Indicators The board has two LED indicators (LED0 and LED1). LED1 is connected to pin 31 and LED0 is connected to pin 30 of the HI-5200PC (U1), The two LEDs are programmable to LED mode ‘00’ or ‘01’ via register 1E (hex), bits [15:14], an…

9, QSG-5200 9 Holt Integrated Circuits Jumper Setting & Definition The HI-5200 ADK PHY evaluation board does not require any jumper for normal operation. At power-up, the HI-5200 ADK PHY is configured using the chip’s internal pull-up and pull-down resistors with its default strapping …