Kaba Mas X-09 Operating Instructions Manual

10, 8 Note: In Dual Combination Mode you may dial either combination fi rst to confi rm. In Super/Sub Mode you must dial the Supervisory combination fi rst and the Subordinate Combination second as you did when fi rst entering the combinations. 15. Dial right (CW). After OP wi…

15, 13 GUIDE TO SYMBOLS Blank Display Lock is powered down. OP Open Right Lightning Bolt Incorrect Combination Dialed. (When this symbol appears in the upper left corner of the display, dial the correct combination.) Lightning Bolt with Error Count Incorrect Combination Dialed xx times. (The …

5, 3 If You Pass Your Target Number When Dialing: Example A: Target Number = 25. If you pass your target number by 4 or more, continue dialing until you reach the target number again. Example B: Target Number = 25. If you pass the target number by no more than 3 numbers, you may continue dialing…

6, Kaba Mas X-09 4 OPEN AND CLOSE THE X-09 (FACTORY COMBINATION) If you have not read the section on “Dialing the X-09”, it is important that you do so before proceeding. Note: The lock is shipped preset to operate in the Single Combination Mode with a Default Factory Combination of 50-25-…

9, 7 Note: If the correct combination is not displayed, you may pull out the change key and the lock will allow you to reset the combination. You must pull out the change key while the display is still fl ashing. When EC appears, insert the change key again and dial the desired co…

2, TABLE OF CONTENTS INTRODUCTION ..............................................................................1 Lock On Back Cover ........................................................................ 1 DIALING THE X-09 .......................................................................2 …