CyClone CTM-1m.DT Operation & User’s Manual

2, Getting Started Plug in your CTM using either the primary or secondary power supply port. Connect your PC to the “network” port on the front of the unit via a standard CAT5 cable and your computers NIC card. Once you have established an Ethernet connection, you can access the web interface…

3, CyClone CTM-1m.DT Network & Email Setup IP Address: Displays the current IP address assigned to the CTM. The user can change the IP in the Network Setup page. Default IP setting is 169.254.1.1. Subnet Mask: Displays the current subnet mask set in the CTM. The user can change this parameter in the Net…

4, GPS Receiver Status & Environment - Continued Longitude: Displays current latitude position of CTM gathered from the GPS receiver. You must have visability of at least 4 satel- lites before this field will show actual coordinates. Altitude: Displays current altitude of CTM. You wi…

8, NOTE: If the unit ~powers up~ in flash loader mode the radio ports will be “on” until the Web server system comes on line and turns off any radio ports that were turned off before. If the unit ~powers up~ into normal web server mode then the radio ports will be on briefly wi…

6, Email Set-up - continued Port Number: This field defaults to Port 25. Unless otherwise specified by your Network Administrator this can remain unchanged. When finished making changes, press the Update Email Setup button at the bottom of the window to save changes. You can rese…