Landice L10 90 Series Installation Manual & Quick Start Manual

14, Installation Unpacking 12 7. Cut open the box and remove bubble wrap (Figure 2-8). Figure 2-8. Packed Base 8. Remove the Treadmill base from the box and place where it will be used as determined in Step 1. One person uses the Grab Bar and two people lift at each front corner as…

5, Landice L10 90 Series 3 1.3. 200 – 240-Volt Treadmills Treadmills marked 200 – 240V AC are intended for use on a circuit having a nominal rating greater than 220V and are factory- equipped with a specific power cord and plug to permit connection to a proper electrical circuit. Ensure the treadmil…

22, Installation Assembly 20 14. On both sides: Attach the Lower Control Assembly to the Upright Brackets using one M8x16 Button Head Allen Screw (5mm) and M8-6 Nut as shown in Figure 2-17. These are unlabeled, below the Allen wrench on the blister pack as indicated by the red arrows in …

27, Assembly Installation 25 26. Remove four M6X75 screws from bag stapled to the console box. Using 5mm hex wrench, secure Display Console assembly to upright with four M6X75 button head cap screws (Figure 2-26). Figure 2-26. Control Assembly Bolts 27. Engage the Accessory Tray tabs in the not…

30, Installation Treadbelt Tensioning 28 2.6. Treadbelt Tensioning 1. Treadbelts are tensioned at the factory prior to shipment and normally need no adjustment. To determine if the treadbelt needs adjustment, straddle the treadbelt by stepping on the straddle covers. Start the treadmill…