Maretron ACM100 Operation & User’s Manual

33, Revision 1.3 Appendix A – NMEA 2000 Interfacing Page A7 PGN 65010 – Utility Phase B AC Power The ACM100 uses this PGN to transmit the real power and apparent power (the vector sum of real power and reactive power) for phase B when the ACM100’s AC Device T…

5, Maretron ACM100 Revision 1.3 Page 1 1 Introduction Congratulations on your purchase of the Maretron Alternating Current (AC) Monitor (ACM100). Maretron has designed and built your ACM100 to the highest standards for years of dependable and accurate service. Maretron’s ACM100 is a devic…

32, ACM100 User’s Manual Page A6 Appendix A – NMEA 2000 Interfacing Revision 1.3 2: Power Factor – This field indicates the magnitude of the power factor supplied by the source in units of 1/16384 (dimensionless). 3: Power Factor Lagging – This field …

15, Revision 1.3 Page 11 Step 2: The Current Transducer has black and white wires. Install the first Current Transducer as follows: a. Connect the black wire to pin 7 (I A+ ) on the ACM100 b. Connect the white wire to pin 8 (I A- ) on the ACM100 c. Disconnect the Phase A hot wir…

31, Revision 1.3 Appendix A – NMEA 2000 Interfacing Page A5 Field 1: Reactive Power – This field indicates the reactive power delivered by the source in units of 1 VAr. 2: Power Factor – This field indicates the magnitude of the power factor supplied by the source in units of 1…