nest Learning thermostat Installation Manual

5, 5. Label wires Peel off the blue labels and attach them to your wires. 6. Disconnect wires and remove base 7. Mark where screws will go Use the bubble level to make sure Nest is level. Tip: Take a picture of the wires on your old thermostat to help you remember. Tip: Wrap the wires arou…

3, nest Learning thermostat Contents Display Screws for Steel Plate Wall Screws Base Nest Screwdriver Optional Trim Plate Steel Plate …

8, Recycle your old thermostat: see nest.com/responsibility Please recycle Nest’s 100% recyclable packaging For more information visit nest.com or call 855-4MY-NEST (855-469-6378) 12. Setup and Nest Account Nest will turn on and start setup. Turn the ring and press to select. …

6, Use trim plate if needed You can cover up holes or marks left by your old thermostat with the optional trim plate. Place the trim plate on the wall and put the base on top so they snap together, then screw them both to the wall. The trim plate can be found in the bottom of…

9, Federal Communications Commission (FCC) Compliance Notice: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a …

7, 9. Connect wires After all wires are connected, make sure they’re flush with the wall. 10. Attach display Press the display until it clicks into place. 8. Attach base 11. Switch power back on Breaker Box Switch …