master mechanic 134455 Owner's Manual

28, master mechanic 134455 28 WARNING: When servicing, use only original equipment replacement parts. The use of any other parts may create a safety hazard or cause damage to the circular saw. Any attempt to repair or replace electrical parts on this circular saw may create a safety hazard un…

25, 25 GENERAL CUTTING – cont’d NOTE: To align the saw blade with the cutting mark, use the guide marks on the front of the sole plate (Fig. 12) and the laser line. Use the 0° cutting mark (1) for right angle cuts. Use only the 45° mark (2) for 45° cuts. The 45° …

8, 8 WARNING: Know your circular saw. Do not plug the charger into the power source or install a battery in the tool until you have read and understand this Instruction Manual. Learn the tool’s applications and limitations, as well as the specific potentia…

2, 2 Product specifications ………….……………………………………………………. 1 Table of contents ……………………………………………………………………... 2 General safety warnings ……………………………�…

18, 18 INSTALLING A BATTERY ON THE CIRCULAR SAW 1. Remove the discharged battery (1) from the circular saw by pressing on the battery release button (2) and sliding the battery backward until it is removed from the circular saw handle (3) (Fig. 3). 2. Slide the fully charged b…

20, 20 SETTING THE CUTTING DEPTH The cutting depth of the blade should be set to suit the thickness of the material being cut. The cutting depth should be approximately 1/8" (3 mm) greater than the thickness of the material being cut. 1. Push the depth adjustm…