Mazda 0000-8E-R10 Installation Instructions Manual

8, Page 8 of 10 TROUBLESHOOTING GUIDE TRAILER HITCH WIRING KIT APPLICA BLE M O DELS : 2017> CX-5 PAR T NUM BER: 0000-8E-R07A 0000-89-R32A TOOLS REQUIRED   METHOD 1aeeggooeooeae�…

1, GENUINE ACCESSORIES Installation Instructions Supplemental Trailer Hitch Harness Part Number: 2017 > CX-5 (GAS 2.5L) 0000-8E-R10 Applicable Models: Tools Required Before Installation A J B C F Large Tie Wraps (QTY 7) Installation Instructions Drill & 6mm Drill Bit Wire Cutters 1.)…

3, Page 3 of 10 B DRILL HOLE IN BUMPER FASCIA Drill + 6mm bit Tape Measure Tools Needed: 1. Locate attachment point (a) on the bumper fascia to measure the drill point for the tie wrap attachment. Measure 40mm towards the receiver tube of the hitch and 15mm upwards. Drill a 6mm hole at the dri…

5, 1. After performing Step 1, verify that a minimum of 50mm has been achieved between exhaust and harness. If not, remove tie wrap and repeat Step 1 above using a new tie wrap. If 50mm has been achieved, move on to Step 2. Due to the extreme high temperatures produced by the exhaust, a min…

7, Page 7 of 10 5 Cross Member 5. While removing all slack, use a large tie wrap to secure the harness to the hitch attachment bracket (d). T ighten the tie wrap and trim the tail using wire cutters. 6. Remove all the slack in the harness near the wire attachment point near the grommet. This…

9, Mazda 0000-8E-R10 Page 9 of 10 INSTALLATION INSPECTION TRAILER HITCH WIRING KIT Inspection Parts Clearance/Fit Scratches/Dirt/ Harness Interference Installation/ Tightening/ Engagement Operation Check Tow Harness Functions Tow Harness Tow Harness Module Ground Screw Driver’s Side Left Rear Interior …