meitav-tec FMHC220-P-FC-MDB01 Owner's Manual & Technician Settings

7, FMHC220-P-FC-MDB01 Owner’s manual & Technnician Settings Tel: +972-3-9626462 Fax: +972-3-9626620 www.meitavtec.com | [email protected] Press the [Select] button – “CLOCK SET” will flash. Press the [+] or [-] buttons - the hours will flash. Adjust the hours using the [+] or [-] b…

1, Installation General points to follow: - Disconnect power to the main board before installing the unit. - The unit MUST be fitted into a standard electrical box (Gewiss Box - GW00001481VR) - The unit should not be installed on an outside wall or where there is an air draft. - The unit must not b…

2, meitav-tec FMHC220-P-FC-MDB01 Wiring Before connecting or disconnecting any wires, ensure that all power supplies have been switched off and all wires are potential-free to prevent equipment damage and avoid electrical shock. Do not run wiring close to transformers or high frequency generating equipment. Complete and verify al…

3, DIP Switch Configuration The DIP Switches are located on the top of the back side of the thermostat. Switch “ON” Position “OFF” Position Default S1.1 Auto-Change Over Sensor Contact Input (Remote switch) ON S1.2 4-Pipe system 2-Pipe system ON S1.3 1 Fan speed 3 Fan speeds OF…

5, Heat Lo o C SET Heat Hi o C SET Lo o C SET Cool o C SET Cool Hi Heat Aux o C SET Aux o C SET Cool Cool Heat o C SET Cool Heat o C SET Technician Settings (Limits for proportional outputs, Proportional band, Dead zone) Adjust the set point temperature to 11°C. Wait until display st…